How to Re-enable disabled disk after a deconnection while array was running ?

[Seb7o]

Hi ! 

I searched a lot but I didn't find an answer for my case (it's not due to a failure), so here I am

I unplugged 2 drives without stopping the array, just for a few minutes, (yeah good idea I know) and now unraid don't want to enable those after I put them back on. I don't want to rebuild the 2 entire drives as I didn't loss any data and a rebuild would take 10 hours, they was just disconnected, not failing.

Luckily I have 2 parity drives, so there both emulated for now

Could someone tell me how I can re enable thoses 2 disabled disks please ?

Thanks by advance.

[JorgeB]

You'll need to rebuild them or do a new config and run a parity check, either way it will take about the same amount of time.

[Seb7o]

Ok I see, Thank you !