Hi

 

After upgrade to 6.12 network is running on 100 rather than 1000, noticed during backup..

Tried manually to change to 1000, used other network socket, did not help.

Other windows PC running on the same switch going well - 1000.

 

What could be wrong?

vault-diagnostics-20230630-1644.zip

Edited June 30, 20233 yr by michael123

unrelated to the question, but I see on the syslog few following lines

 

Jun 30 16:40:21 Vault kernel: critical medium error, dev sda, sector 15589184 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 2

 

Also, this week the server once refused to recognize flash as boot device.. 

 

What should I do? Replace the flash drive? What is the procedure?

I upgraded from 6.12.1 to 6.12.2, but still same 100 MBit/sec

 

Question - how difficult is to go back to 6.11.xx ?

 

I have ethtool output for 6.11.5

 

Settings for eth0:
    Supported ports: [ TP ]
    Supported link modes:   10baseT/Half 10baseT/Full
                            100baseT/Half 100baseT/Full
                            1000baseT/Full
    Supported pause frame use: Symmetric
    Supports auto-negotiation: Yes
    Supported FEC modes: Not reported
    Advertised link modes:  10baseT/Half 10baseT/Full
                            100baseT/Half 100baseT/Full
                            1000baseT/Full
    Advertised pause frame use: Symmetric
    Advertised auto-negotiation: Yes
    Advertised FEC modes: Not reported
    Speed: 1000Mb/s
    Duplex: Full
    Auto-negotiation: on
    Port: Twisted Pair
    PHYAD: 1
    Transceiver: internal
    MDI-X: on (auto)
    Supports Wake-on: pumbg
    Wake-on: g
        Current message level: 0x00000007 (7)
                               drv probe link
    Link detected: yes

 

For 6.12.x that's same except it is 100Mb/s

 

and driver info for 6.11 is

 

driver: igb
version: 5.19.17-Unraid
firmware-version: 3.25, 0x800005cc
expansion-rom-version: 
bus-info: 0000:03:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes

 

while for 6.12 is 

 

driver: igb

version: 6.1.36-Unraid

firmware-version: 3.25, 0x800005cc

expansion-rom-version:

bus-info: 0000:03:00.0

supports-statistics: yes

supports-test: yes

supports-eeprom-access: yes

supports-register-dump: yes

supports-priv-flags: yes

 

 

 

 

I played with the cables, probably I had a bad connection 🤡

Sorry