Failed drive replacement shows "Unmountable: Unsupported or no file system"

[tmaults]

I had a 3TB data drive fail on my server so I shutdown the system removed the failed drive and replaced it with a 6TB drive. After starting the system, with the array stopped, I selected the new drive as disk 1 (the failed location) in the array. After starting the array the system did a rebuild on the drive but it is  showing "Unmountable: Unsupported or no file system". I have rebooted the server since then but still showing the same error.

 

Any help appreciated...

diag attached.

fourty2-diagnostics-20230821-1232.zip

[itimpi]

Was the stove showing as unmountable before the rebuild?

 

The correct handling of Unmountable drives is covered here in the online documentation accessible via the ‘Manual’ link at the bottom of the GUI or the DOCS link at the top of each forum page.

[tmaults]

Not that I remember, it was expecting it to fail because I was seeing errors and had a replacement available so I didn't record the particulars. I will look at the link you provided.

[tmaults]

I ran the file check during my troubleshooting earlier today but I didnt see any errors

 

 

file check.txt

[itimpi]

You probably need to run it again on the rebuilt disk (without the -n option) and if you get similar results the drive should mount after the array is restarted in normal mode.

[tmaults]

itimpi

That fixed it! Thank you!