September 3, 20232 yr I recently installed a new motherboard, but no longer able to connect. I can get into GUI safe mode and for some reason when I toggle a setting in network setting like eth0 bridge mode on and off it shows up on the network I also noticed on the boot loader screen it says unable to find eth0 device but then is shows the IP address. Are my setting incorrect? or is there another issue. Also, I didn't have this before where there is eth0, 1, and 2? Unless that's normal. server3.0-diagnostics-20230903-0926.zip
September 3, 20232 yr Community Expert Solution You might want to delete (or rename) the config/vfio.cfg file on the flash drive. There is a good chance that with a new motherboard the device ID's for passed through devices are different.
September 3, 20232 yr Author Thank you I ended up deleting the network.cfg and network-rules.cfg file and had Unraid start fresh, and I was able to connect just fine.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.