December 6, 20232 yr Hello, when I boot my server I can access it over my lan but when I start my array, it disconnects and I cannot access the UI until I reset the server again. Can someone take a look at my log and see if there is anything that sticks out? I did a smart test on my array drives and they come back as passed. syslog
December 6, 20232 yr Community Expert Nothing obvious that I can see, does booting in safe mode help?
December 6, 20232 yr Author 17 minutes ago, JorgeB said: Nothing obvious that I can see, does booting in safe mode help? no unfortunately. it still disconnects from the lan. just tried it and i have the same issue. heres an updated syslog from booting into safe mode. i see at the bottom that br0 entered disabled state. could that be when it disconnects? syslog
December 7, 20232 yr Community Expert Dec 6 13:18:12 Server kernel: r8169 0000:26:00.0 eth0: RTL8125B, 2c:f0:5d:a1:c1:56, XID 641, IRQ 81 Dec 6 13:18:12 Server kernel: r8169 0000:26:00.0 eth0: jumbo features [frames: 9194 bytes, tx checksumming: ko] This can be a problem with current releases, either change the MTU to 1500 or use the Realtek driver plugin.
December 7, 20232 yr Author Solution 6 hours ago, JorgeB said: Dec 6 13:18:12 Server kernel: r8169 0000:26:00.0 eth0: RTL8125B, 2c:f0:5d:a1:c1:56, XID 641, IRQ 81 Dec 6 13:18:12 Server kernel: r8169 0000:26:00.0 eth0: jumbo features [frames: 9194 bytes, tx checksumming: ko] This can be a problem with current releases, either change the MTU to 1500 or use the Realtek driver plugin. Thanks for the help! I'll be sure to do that. I think I found out my problem. I checked the disks and they all passed. Then, I checked my Docker settings and saw it was set to macvlan. I switched to ipvlan and it resolved the problem. Everything is as it should be now.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.