Edit- Found JorgeB's post.

Just would like to confirm at this point that I can "click on the pool and then "Remove Pool" or set the pool slots to 0."

Thanks for your patience & understanding.

JeffC

Hi Everyone,

Sorta freaking out a little, been an UnRaid user since 2018, and never really had an issue. Wanted to do the upgrade to 7.2.5 because of the copy/paste issue, so pulled the trigger this morning. Didn't see any errors, but after I rebooted and then tried to start the array, I'm getting the error message "Wrong Pool State cache - missing devices". No other changes in the system, no drive changes or reconfigurations. I have searched the error and most of the results seem to be related to system configuration changes.

Any help or guidance would be very much appreciated!!

Pool Devices

Device	Identification	Temp	Reads	Writes	Errors	FS	Size	Used	Free
Cache	unassigned

Slots:	1

Boot Device

Device	Identification	Temp	Reads	Writes	Errors	FS	Size	Used	Free
Flash	Cruzer_Glide - 31.5 GB (sda)	*	0.0 B/s	0.0 B/s	0	vfat	31.5 GB	1.78 GB	29.7 GB

Edited May 7May 7 by JeffC
additional information

11 hours ago, JeffC said:

Just would like to confirm at this point that I can "click on the pool and then "Remove Pool" or set the pool slots to 0."

Yep

Thank you very, very much Jorge!! All good now.