Hi Everyone,

Not sure exactly where everything went wrong, but both Sab and Deluge WebUIs aren't loading at the moment. Here's what happened:

A while ago, I followed SIO's video about routing docker containers through wireguard here. Every 30-60 days, the connection seems to lose connection/crap out/get reset/whatever. When that happens, I just download a new .conf file for a new exit location, set up wg1 (instead of wg0), then switch all the containers to the new wg1 network. This has worked pretty well in the past until last night. I got a couple of errors when trying to get the new config file from SIO's PIA Generator docker, but eventually got one that worked. I performed the same steps and the downloads that were stalled began. However, it showed an error saying that "Connection was lost to Sab/Deluge" so I refreshed the page and...nothing.

I poked around the forums and saw a couple others have a similar issue, so I restarted the server and double checked that there were no port conflictions. The logs don't seem to be showing any egregious error (to my untrained eye), but they're attached below. All other dockers that use this network seem to be affected - they start, but the WebUI doesn't load.

Anyone run into this before? Thanks very much for your time!

Deluge_Logs.txt SAB_Logs.txt

Edited May 27May 27 by bonustreats

Well, I spoke WAY too soon.

Apparently, my NEW .conf died as well, so the wg1 network was inactive. I made a new .conf file, made the new network, and everything seems to be running again.

Apologies for any hassle and thanks!

(I'll edit the title to closed)