Skip to content
View in the app

A better way to browse. Learn more.

Unraid

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Parity Disk Disabled and Unable to Run SMART Test on a Drive

Featured Replies

Hello! Having issues with a Parity Drive being disabled after setting a new server with brand new drives and setting up the array letting it run overnight i noticed my parity drive is showing "Parity Device Disabled, Click to spun down" yet on the dashboard it shows healthy and parity valid, so I tried a few things after researching through the forums:

  • Tried running a SMART Diagnosis and it won't work but under Identity it shows SMART support enabled

  • Tried stopping the array and starting it without the drive, stopping again and re-adding parity drive under the same slot, still shows Disabled

  • Shutdown the system and tested using multiple SATA ports on the motherboard, even ones that are confirmed working along with different SATA Cables, didn't work

  • Verified everything is connected properly with my power supply

My setup is the following:

x2 Ironwolf Pro 12TB Drives

x1 M.2 SSD Cache

A850GL MSI Power Supply

Not sure if it matters but I did notice that this drive under Main does not show temperature like my other one which is the same type of drive, additionally it makes a weird electrical noise like a robot on startup, it eventually stops and stays silent, unsure if this sound or behavior is typical of this type of drive.

Attaching Dianostics too, if it helps

Screenshot_20261119_120849.pngScreenshot_20261119_120759.png

Any help would be greatly appreciated!

fgserv-diagnostics-20261119-1206.zip

Unfortunately, the parity drive appears to be faulty, so cables or ports don't look like the cause.

The drive is not identifying itself correctly. It reports its model as "ST12000NT001" without the usual suffix, and with older ATA/SATA levels, while your other IronWolf Pro reports itself normally as ST12000NT001-3MD101. Every attempt to read from it fails with "not ready, power cycle required". That is why there is no temperature, the SMART data can't be read and SMART tests won't start, and the array disabled it on the first writes. It does the same after reboots and on different SATA ports, and the noise you hear at power-on fits a drive that isn't starting up correctly.

Since it's a new drive, I'd recommend returning it to the seller or requesting an RMA. If you want to double-check first, you can connect it to another computer or a USB dock. It will most likely show the same problem.

Note that the "Parity is valid" message and the parity history on the Dashboard come from the earlier run. Right now the array is running without parity protection. Once you have the replacement, stop the array, assign the new drive to the parity slot and start the array. Parity will then sync onto it. Please post new diagnostics if anything looks wrong after that.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.