Tezmo Posted October 17, 2012 Share Posted October 17, 2012 Gentlemen/Ladies, I replaced my 2tb parity drive with a 3tb parity drive. I now wish to take the old 2tb parity and use it as data; can someone direct me regarding the steps I need to take to perform this? Does it need another pre-clear? Would doing it hurt? Thank you all Link to comment
Joe L. Posted October 17, 2012 Share Posted October 17, 2012 Gentlemen/Ladies, I replaced my 2tb parity drive with a 3tb parity drive. I now wish to take the old 2tb parity and use it as data; can someone direct me regarding the steps I need to take to perform this? Stop the array, assign it as a data drive. Does it need another pre-clear? If you do not preclear it, unRAID will clear it keeping the array off-line for 5 or more hours while it does.Would doing it hurt? A preclear on the drive would not hurt at all. Link to comment
Tezmo Posted October 17, 2012 Author Share Posted October 17, 2012 Thank you Joe; I shall perform a pre-clear and assign it to the array upon completion! Very helpful and much appreciated Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.