sentein Posted December 31, 2017 Share Posted December 31, 2017 (edited) I am attempting to setup a second unraid server. I would like to run multiple vms from the second server and i cannot figure out how to enable bridges. I have set the eth0 and eth2 to be bridged but i cannot select a br connection to bridge to. Matter of fact the only options for bridging that show up are eth0-eth2. I am not 100% sure what i am messing up. I have a pfsense vm installed for experimenting. In the end i am going to have to bridge 4 seperate ports or pass through at least 2 full nics for what i would like to impliment. Any thoughts on the bridge and what i am missing are welcome. Edit: Downloaded the 6.4 Pre-release and found the new routing table in the Network settings. Much quicker to find routings than before ans nothing is assumed. My Bridges were there but i could not see the correlation between physical ports and bridges. Thanks Anyhow. Edited January 2, 2018 by sentein Found my own Resolution Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.