Jump to content

Bridging issue in Network setup cannot select ip for dockers


Recommended Posts

HI Guys,


If I enable bridging in network setup so that my VMs get an IP from my router then it stops my dockers being able to have their own assigned IP address.


After enabling bridging then restarting the docker - when I go to the dockers, the ability to select bond 0 (my two nics are bonded) has gone and the only choices are bridge host or none.


I don't think I am doing anything wrong - has anyone else seen this?  OR have any suggestions?






brdiging enabled.jpg

bridgingenabled-noway to select.jpg

Link to comment


This topic is now archived and is closed to further replies.

  • Create New...