New NIC Card Reports Down but can ping it

So I added a new NIC (10GB) and it's detected as eth2.  I can assign it a static IP and ping it, but unRAID reports it as down 'Interface Ethernet Port 2 is down. Check cable!'

Looking in the log, I'm reading it as the link should be set to UP.  Am I missing something?

Running unRAID 6.5.3

Thanks much

Jul  8 14:36:16 unRAID-1 kernel: Intel(R) 10GbE PCI Express Linux Network Driver - version 5.3.6
Jul  8 14:36:16 unRAID-1 kernel: Copyright(c) 1999 - 2018 Intel Corporation.
Jul  8 14:36:16 unRAID-1 kernel: ixgbe 0000:01:00.0: failed to load because an unsupported SFP+ or QSFP module type was detected.
Jul  8 14:36:16 unRAID-1 kernel: ixgbe 0000:01:00.0: Reload the driver after installing a supported module.
Jul  8 14:36:17 unRAID-1 rsyslogd: environment variable TZ is not set, auto correcting this to TZ=/etc/localtime  [v8.33.1 try http://www.rsyslog.com/e/2442 ]
Jul  8 14:36:17 unRAID-1 rsyslogd:  [origin software="rsyslogd" swVersion="8.33.1" x-pid="1500" x-info="http://www.rsyslog.com"] start
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1: PCI Express bandwidth of 32GT/s available
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1: (Speed:5.0GT/s, Width: x8, Encoding Loss:20%)
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1 eth1: MAC: 2, PHY: 1, PBA No: E66560-005
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1: 90:e2:ba:18:a3:65
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1 eth1: Enabled Features: RxQ: 8 TxQ: 8 FdirHash 
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1 eth1: Intel(R) 10 Gigabit Network Connection
Jul  8 14:36:17 unRAID-1 kernel: ixgbe 0000:01:00.1 eth2: renamed from eth1
Jul  8 14:36:18 unRAID-1 rc.inet1: ip -4 addr add 127.0.0.1/8 dev lo
Jul  8 14:36:18 unRAID-1 rc.inet1: ip -6 addr add ::1/128 dev lo
Jul  8 14:36:18 unRAID-1 rc.inet1: ip link set lo up
Jul  8 14:36:18 unRAID-1 rc.inet1: ip link set eth0 mtu 9000
Jul  8 14:36:18 unRAID-1 kernel: e1000e 0000:00:19.0 eth0: changing MTU from 1500 to 9000
Jul  8 14:36:18 unRAID-1 kernel: e1000e 0000:00:19.0: Interrupt Throttle Rate off
Jul  8 14:36:18 unRAID-1 rc.inet1: ip -4 addr add 192.168.166.23/255.255.255.0 dev eth0
Jul  8 14:36:18 unRAID-1 rc.inet1: ip link set eth0 up
Jul  8 14:36:18 unRAID-1 kernel: IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
Jul  8 14:36:18 unRAID-1 rc.inet1: ip link set eth2 mtu 9000
Jul  8 14:36:18 unRAID-1 rc.inet1: ip -4 addr add 192.168.166.26/255.255.255.0 dev eth2
Jul  8 14:36:18 unRAID-1 kernel: ixgbe 0000:01:00.1 eth2: changing MTU from 1500 to 9000
Jul  8 14:36:18 unRAID-1 rc.inet1: ip link set eth2 up

Edited July 8, 20187 yr by kbrutlag