My wife decided to pull the power cord for an incoming storm without doing a clean shutdown first, and now I have a rather large number of errors. I've done a parity check with write corrections enabled and they are still there. I've attached a diagnostics log.

 

It's also saying that my Movies share isn't fully protected. I'm pretty sure it's not set to use the cache drive at the moment and I've run the Mover to make sure, but it won't clear the icon.

 

Anybody have any ideas what's going on? I'm running v6.6.3.

tower-diagnostics-20181022-2022.zip

Diagnostics are after rebooting, run a correcting parity check and post new diags if the sync errors aren't fixed.

 

P.S, you need to replace the SATA cable for the cache device.

 

31 minutes ago, actioncheese said:

It's also saying that my Movies share isn't fully protected. I'm pretty sure it's not set to use the cache drive at the moment and I've run the Mover to make sure, but it won't clear the icon.

Set use cache to "Yes", run the mover and when done set back to use cache "No"

Thanks for that, I'll give it a go and report back with a new log after another parity check.