December 5, 201015 yr I wasn't able to find this and the directions aren't very clear. I have one of the CSE-M35T-1 HotSwap Bays and it comes with a 10-pin connector that has 5 individually labeled wires in it. Where doesn't this go? I assume that there is one wire for every hard drive bay, but I can't figure what installs where. Also do I need to enable buzzer reset? It is disabled by default, but I'm not sure what it does. Thanks
December 5, 201015 yr Author Here is a picture http://www.flickr.com/photos/50701789@N08/5235279678/. Is it only needed for a raid card?
December 5, 201015 yr Blackcat, I do not have my documentation handy. this is the activity led cable, it is used for some case, you can get the activity per disk. if you do know what it is used for, let's make it easy, it simply means you don't need it and it does not change a thing anyway R
December 5, 201015 yr Author Blackcat, I do not have my documentation handy. this is the activity led cable, it is used for some case, you can get the activity per disk. if you do know what it is used for, let's make it easy, it simply means you don't need it and it does not change a thing anyway R Thanks. I would think you would need card that supports the activity lights since a motherboard doesn't natively support it (as far as I know).
December 6, 201015 yr Thanks. I would think you would need card that supports the activity lights since a motherboard doesn't natively support it (as far as I know). yup,, just got back home, and these cables are activity cables, as you mentioned usually motherboard do not support such cabling, but some (mostly servers) cases do... Cheers, R
Archived
This topic is now archived and is closed to further replies.