Hello everyone,

 

I recently updated to v. 6.8.3. A few weeks after upgrading I had a disk become disabled. I figured since the disk was older it was a problem with the disk, so I ordered a new drive. I hooked the drive up today and went to rebuild. I initially had problems with the rebuild since it had been a while since I had performed one. I did go through the updated instructions on the FAQ and it seems to be in process now.

 

I did start to receive 'UDMA CRC error count' errors on Disk 2 of my configuration. I had acknowledged the errors previously after an upgrade because they could have been historical errors, but the error count goes up. Is there anything else to look at to see if the drive is failing or if it is a deeper issue?

 

I have attached the diagnostics. Any help is greatly appreciated. At this point, my biggest fear is losing data.

 

tower-diagnostics-20201108-2233.zip

Edited November 9, 20205 yr by voldak

I think those are generally connection issues.

You should check Data and Power connections on both ends.