mSedek Posted December 11, 2020 Share Posted December 11, 2020 was doing some test with sata controllers and at the end found what to pass and what not to the vms but I forgot to remove one of the controllers, that controller was now managing the cache disk but i didnt remember that one of the vm has it passed and I started the vm everything crashed, rebooted, removed the controller from the vm and everything is working but the primary disk1 and parity2 are diasabled, did autotest and both are perfect, they are fine in bios, their power is perfect, in UNRAID wiki says that if I remove the drives from the motherboard, start the array, then shut it off and connect the drives again, they will get reenabled but not. they are still disabled and I dont know what to do. Help? Quote Link to comment
mSedek Posted December 11, 2020 Author Share Posted December 11, 2020 (edited) solved the issue by unassigning the devices, starting the array, then stopping the array and assigning them to a different slot, I mean, what was the disk1 now is parity2 and what was parity2 now is disk1. hope it helps someone there Edited December 11, 2020 by mSedek Quote Link to comment
itimpi Posted December 11, 2020 Share Posted December 11, 2020 Could you please give us the link to the wiki entry you used as the steps you mentioned are not sufficient to achieve what you wanted so it may need correcting. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.