- Minor
I am doing a parity swap: replacing my old 3TB parity drive with a 4TB drive and replacing one of my data drives with the former parity drive. Currently all my parity data is being copied from the old drive to the new one and the following read/write speeds are being reported:
The reported speeds seem to be stuck at the values shown in the screenshot.
The progress on the copy is about 1% every 5 minutes. I am not sure whether this is 1% of 3TB or 1% of 4TB. However the progress that I am seeing equates to roughly 100 Mb/s, which corresponds to speeds I am used to during parity checks.
I am assuming that the speeds shown are actually the speeds of the disks before I started the swap procedure (when my array was idling). It would be more helpful if a) the correct speeds were shown or b) no speeds were shown (no speeds beats incorrect speeds IMO).