Mr_Assister

Just an FYI: I swapped out for a new flash drive and haven't had any crashing for 2 weeks.

My apologies, I forgot about this yesterday when troubleshooting the flash drive.

Ok, I did that and I'm now running off a new Flash Drive and the web GUI Is much faster with no crashes so far. Is there something I can do to make sure I don't have anything doing excessive read/writes to the flash drive that might kill this one in the future? I currently have 20k reads and 10k writes after 19hours of uptime.

Slightly unrelated, but I tried using the Unraid USB creator to flash a new flash drive with my usb backup.zip and it looks like it isn't copying the config folder? When I boot to the new usb drive, it acts as if its a completely new OS install.

This server has been running fine for about 5 years without any issues, is the c-state issue something that can occur on its own after some time?

Here is the Diagnostics. unraid-diagnostics-20250513-0914.zip

Lately my unraid server has been crashing frequently, I have done the following to try to resolve it, Can anyone give me any suggestions? This is the error I saw locally from a monitor connected to the machine: Unraid login: php-fpm[9655]: [WARNING] [pool www] child 3927911 exited on signal 9 (SIGKILL) after 64.252728 seconds from sta... /usr/local/sbin/monitor_nchan: line 59: 3931614 Segmentation fault logger -t $nchan_id -- "Stop running nchan processes" /usr/local/sbin/monitor_nchan: line 59: 93813 Segmentation fault logger -t $nchan_id -- "Stop running nchan processes" /usr/local/sbin/monitor_nchan: line 59: 202725 Segmentation fault logger -t $nchan_id -- "Stop running nchan processes" I have enabled the syslog server, but there are no errors showing in there. I notice the crashing when I attempt to log into the web interface and it either freezes or stops loading a new page. At that point SSH no longer works, and you can't login locally either, BUT docker continues to run and I can still reach the web interface of several docker containers. the only way to get it working again is to pull the power and completely restart the machine. I'm unable to run "diagnostics" because once the crash happens I can't log in to the server to create the diagnostics, and after I restart, it doesn't have anything saved from before the restart. I ran MEMTEST 1 pass with 0 errors. I updated to the latest version 7.1.2 The crashes seem to happen when I'm attempting to load a new page in the web interface too fast.