mjone4

So I plugged in the previously thought to have failed old disk1 and ran the smart test and it says passed. I ordered more cables so I can plug all the drives in and then see what happens. Is there a process I should do like make them unassigned and then try to look and see what files are on before I add them to the array? I appreciate everyones help so far.

It was marked as disabled and I assumed it was nonfunctional.

Old parity is now unmountable in disk3, old disk1 failed. Old disk2 should be fine but is currently not attached to the system. I’m pretty sure I did a new config in order to get the new parity drive setup. Likely was a mistake as I’m finding out. Just looking to see what I should be able to recover at this point. Thank you for your help

Looking to get some help before I mess things up more than I probably already did. I thought drive replacement was going to be easier than I came across. I will attempt to describe what I have already done and what I'm trying to fix. I had a data drive fail and ordered multiple new drives that were larger than the previous parity drive. Previous drive setup was 1 parity, disk 1 of data failed and then disk 2. I believe I did a New Config and currently have one of the new drives in the parity slot, a new drive in the first data slot showing xfs and seems to be running, a new drive stating "Unmountable: Unsupported partition layout" in the second disk slot and the old parity drive in the 3rd data slot stating "Unmountable: Unsupported or no file system." Cache drives unchanged. Old disk 2 is currently not connected to the system. It seems at though it is remembering some of the shares, but none of the data is in them. Am I past the point of saving the old data after a new parity was built? Can I save files from the old disk 2 and move them somehow? I would appreciate any guidance you all can provide. Thank you! tower-diagnostics-20240117-2129.zip