SquareGravy

Members
  • Posts

    7
  • Joined

  • Last visited

SquareGravy's Achievements

Noob

Noob (1/14)

0

Reputation

  1. I don't know where to see if it's being emulated or not. I unassigned and started the array and now its showing under "unassigned" as Dev 1. If I go into Krusader I can see the folders for all my disks under my "Media" and I can browse into Disk 3 and everything is there, is that what it means by "emulated"?
  2. Update again: Rebooted and the drive is back... When adding it back to Disk 3 it says "All existing data on this device will be OVERWRITTEN when array is Started". Is that right? It'll just rebuild itself from the parity drives right? Should I start in Maintenance mode to be safe? Thanks. Edit: Disk 3 is now showing the same UDMA error as Disk 2 so I'm thinking its the board in the case that's the issue.
  3. Update: Checked in BIOS. I forgot the BIOS on this motherboard are weird (MSI) and when it boots it only registers 4 drives. If I go to SATA configuration within the BIOS it only shows 4, but if I go to to Boot Menu, I can see all 8 drives + my NVMe cache drive, so I have no idea.
  4. Appreciate the response. I'll check BIOS now. I'm wondering if the drive board in the case is going bad. Should have mentioned this but Disk 2 has been showing a UDMA CRC Error Count warning for a few days. The drive that failed had no warning at all. Wondering if I should replace the whole thing. I saw the UDMA error is usually a cable issue, but since its a single board for all 8 disks, there's just two power cables plugging into it and a sata cable for each drive.
  5. Hello everyone, Pretty sure my disk is either dead, or hoping (sort of) it's a cable issue. Noticed this morning my Disk 3 was showing as disabled. Tried following the steps here: https://docs.unraid.net/unraid-os/manual/storage-management/#rebuilding-a-drive-onto-itself but upon restarting the array, it says "not installed" for Disk 3. Before starting the array it showed "no device". I've attached my diagnostics. If the disk isn't showing at all would that be a power issue? If it is I'm not sure how I could fix that as its part of the case that all 8 drives plug in to for power... This is also a data disk so if it is a dead drive I'm hoping its an easy fix of just popping in a new drive and the array rebuilds itself... Any help is appreciated, thanks. tower-diagnostics-20240306-0833.zip
  6. Anyone having issues with the latest plexpass update? I updated this morning and now it basically nukes my server after running for a few minutes. Lose all network connectivity and and I have manually reboot. Only started happening after installing the update this morning. And how can I downgrade to the previous version? Edit: If anyone else encounters this issue, go to edit the container and change the repository to "binhex/arch-plexpass:1.40.0.7775-1-01" to go back to the previous version.
  7. I'm having the same issue as a lot of other people where it's been working no issues for a year and for the last two weeks I haven't been able to access the WebUI. I haven't changed anything and I do not have the VPN enabled. Below are my logs. I have no idea what the issue could be. Any help is appreciated.