WhiteGuardian

Members
  • Posts

    4
  • Joined

  • Last visited

WhiteGuardian's Achievements

Noob

Noob (1/14)

1

Reputation

  1. After checking the config of the controller, I discoverd that the config of the drives needs to be reset. Because it seems that there was a config on the drives, from the HP P420 Controller. The Lines Masked from HBA and Drive exposed to OS, was the same on all the drives that were not passed through to unRAID. Smart HBA H240 in Slot 3 (HBA Mode) HBA Drives physicaldrive 2I:1:1 Masked from HBA: The drive contains controller configuration data and has been disabled in order to protect the configuration data. Please run the "modify clearconfigdata" command on the drive to re-enable it. Port: 2I Box: 1 Bay: 1 Status: OK Drive Type: HBA Mode Drive Interface Type: SAS Size: 2 TB Drive exposed to OS: False Logical/Physical Block Size: 512/512 Rotational Speed: 7200 Firmware Revision: MS06 Serial Number: YGGDJ8RA WWID: 5000CCA01C16C649 Model: HITACHI HUS723020ALS641 Current Temperature (C): 30 PHY Count: 2 PHY Transfer Rate: 6.0Gbps, Unknown Drive Authentication Status: OK Carrier Application Version: 11 Carrier Bootloader Version: 6 Sanitize Erase Supported: False Shingled Magnetic Recording Support: None After doing this with the HP ssacli all the drives were shown in the unRAID GUI. I've got to do this on all drives from 2I:1:1 - 2I:1:n I've done this in a Live Ubuntu. In my case: ssacli controller slot=3 physicaldrive 2I:1:1 modify clearconfigdata Thanks again for the Help. Best Regards Thomas
  2. Hello JorgeB, I have set the Controller to HBA Mode, so it should pass through all drives to unRaid. I will check the BIOS again. Thx.
  3. Hello ChatNoir, The drives are fomatted in xfs - encrypted, but i think that this should not be the problem. Here is the Diagnostics zip undragon-diagnostics-20210830-1732.zip
  4. Hello everybody, On my HP DL380e G8 Server I replaced the original P420 Controller with a H240 configured in HBA mode. Hoping that this card will provide me the S.M.A.R.T values and the Temps from the HDD's. I've got 12 Drives attached and with the P420 all Drives were shown, now with the H240 I see only 3 drives in unRaid, but in the iLO console from the server, there will be all 12 drives listed. So I think that the controller is not passing it through. The weird thing about this is, that there are only this 3 drives were shown, no matter in what slot they are. Is there something else to configure? Thanks. Best Regards Thomas