cbrackbill

Thank you @JorgeB! That solved the issue and I was able to update to 6.12.1. I appreciate everyone who helped along the way!

Thank you! I will try this when I get home from and work and report back.

So, I think this may have to do with a problem "Fix Common Problems" keeps telling me about. I have 2 NICs currently but, used to have 3. eth0 - 10...... eth1 - 192..... The removed one was 10.13.12.50, and I changed eth0 to take over the removed pcie fiber card. FCP tells me eth2 has the same IP as eth0 but, eth2 is no longer installed. Would I have to install eth2 back into the machine to fix this issue?

Thank you! Rolling back got me up and running for now. I will check back in tomorrow evening and see if there are any updates.

My appologies, I only have a KVM hooked to this server, no SSH. Hopefully this picture of the report will work.

Start reported no errors. It would come back with "Starting...." then go back to prompt. New log attached. This log is the new USB drive with the old config folder copied over to it. Thank you for your help! clover-diagnostics-20230621-1952.zip

I ran the command. It said "no change to report" and I do not have webui. I had ran one for "status" and it says it is not running. I ran one to start it but, it reports nothing and goes back to prompt.

I tried a new flash drive with a fresh install. I can access the webui that way. I copied the config folder off my original flash drive and put it on the new flash drive, back to no webui.

I did the update this morning from 6.12.0 to 6.12.1. I had no issues with 6.12.0. With 6.12.1 I am not able to access the wedui. Most of the topics I am finding have to do with 6.12.0 having this issue. I did try some of the fixes this community was posting, with no luck. I am hoping someone can help me out. Thank you! clover-diagnostics-20230621-1614.zip