Houwie70

Thanks!! that did it!

I figured but this is the output I get on both drives: smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.10.28-Unraid] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Vendor: SEAGATE Product: ST32000444SS Revision: KS68 Compliance: SPC-3 User Capacity: 2,000,398,934,016 bytes [2.00 TB] Logical block size: 512 bytes Rotation Rate: 7200 rpm Form Factor: 3.5 inches Logical Unit id: 0x5000c50033f0e26f Serial number: 9WM4RQBC Device type: disk Transport protocol: SAS (SPL-3) Local Time is: Sat Dec 4 12:22:49 2021 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled Temperature Warning: Enabled === START OF READ SMART DATA SECTION === SMART Health Status: OK Current Drive Temperature: 0 C Drive Trip Temperature: 0 C Elements in grown defect list: 1 Error Counter logging not supported Device does not support Self Test logging So its really not giving me a lot here.

I have 2 2TB sas drives in an array with an H310 mini in IT mode. The two drives are Seagate ST32000444SS drives and refuse to give out any SMART data at all. I've looked all over the internet and found that someone with an sas Seagate drive discovered a firmware issue with the drive resulting in the smart data pages (something like that) not being provided. They created a workaround on smartmontools and this was included with version 6.5. Here is the link to the thread: (https://web.archive.org/web/20210419091225/https://www.smartmontools.org/ticket/678). Does anyone know if I should try to update the firmware on the drive or try something else?