OxfordJon

Looks like everything is back up and running. Ran the rebuilt and the parity check and all seems back to normal. I appreciate your guidance with the diagnostics, I've sent you some beer money.

New cables are in and everything looks like it has started apart from Disk 3 which is noted as Not Installed, contents emulated. New diagnostics attached. Thank you tower-diagnostics-20250121-1520.zip

I had some unused cables which I swapped in. I've just ordered new power and data so will send new diagnostics once they are in.

Done. Checked all cables. Disk 3 looks like it has failed. Initially it was saying the data was emulated and now it just says Not Installed. I don't have a replacement drive so ideally I just want to remove that drive from the array (ideally without loosing the data). Hers the diags: tower-diagnostics-20250120-1003.zip

I am hoping someone can help. I have had a drive fail (i think) it became disabled. I tried removing it and restarting the array but it looks like I am getting a load of errors on the other drives? I have changed all the sata cables and checked all the power cables which seem fine. Before I try to start the array everything seems line and no errors in the logs. When I start the array I get lots of errors on ata6.00 and ata3.00, neither are the drive which originally became disabled. They are both the same type of drive, ex server drives which I have had for about 3 months and up until now have run fine. I would appreciate if someone can take a look. Thank you tower-diagnostics-20250118-2203.zip