Cambridge

Thank you for your responses, Found controller in IDE mode. Switched to AHCI and all back to normal. Thank you.

Thank you, Swtiched that setting. Things all back to normal. On Unraid 6, things were fine. On RC 1, things didnt like IDE mode. Thank you

Hi, recently updated to Unraid 7.0.0 rc1. Since then, my disk groups and parity wont spin down after the 15 minutes of no activity. I have ran Disk Activity, and not seeing anything out of ordinary. I recently installed pihole, could it be related to that? When I manually try to spin down disks from MAIN page, only 1 disk in array spins down. 4 array disks and parity keep spinning, Not sure where to go from here. Thank you tower-diagnostics-20241228-1203 (1).zip

Hi, recently updated to Unraid 7.0.0 rc1. Since then, my disk groups and parity wont spin down after the 15 minutes of no activity. I have ran Disk Activity, and not seeing anything out of ordinary. I recently installed pihole, could it be related to that? When I manually try to spin down disks from MAIN page, only 1 disk in array spins down. 4 array disks and parity keep spinning, Not sure where to go from here. Thank you tower-diagnostics-20241228-1203.zip

tower-diagnostics-20240101-0200.zip

Turns out it appears my cache drive was the cause of my issues. new cache disk. Moved appdata, domains and system back on cache. All systems back online. Thank you for your help.

Thank you, will try that. Appreciate it

Thank you, you recommend moving appdata, domains and system shares to cache pool? I am waiting on a new ssd for cache. hopefully tomorrow. how do I go about putting those on cache? selecting cache pool in settings for those shares?

Apologize again, a bit new to all this, but learning. I must have downloaded diagnostics prior to starting array and uploaded incorrect one. I am rebuilding disk 3, on a spare 12Tb I had sitting around. the "old" disk 3, is showing in disk devices and appears mountable. When it is finished rebuilding the array, I will run pre clear on old disk 3, and hopefully be able to add back to the array. Still no cache disk ssd showing. Thank you for your help. tower-diagnostics-20231228-1501.zip

Im sorry about that. here it is. I have replaced the Disk 3, and it is rebuilding, I cannot see the SSD in bios. Can see 4 out of 5 WD in bios. Rearranged some SATA cables on the MB and now I see the old disk 3 in unassigned devices, but it was showing emulated when I tried adding it the the array. tower-diagnostics-20231227-2221 (1).zip

Hello, I shut down my array, and when went to reboot, my cache drive, and disk 3, are no where to be found. I have rebooted a few times, with no luck. Here is my diagnostic, any help would be greatly appreciated. syslog.txt