Eitsch

Hi, unfortunately no ... did not find a solution.

Dear all, I have an Intel n5105 CPU / JasperLake iGPU running with unRAID 6.12.3. I want to run Jellyfin with hardware transcoding. 1) unRAID I think the card is properly loaded as far the driver side tells. The file „/boot/config/modprobe.d/i915.conf“ holds „options i915 enable_guc=2“, I also tried setting the value to „=3“. In „dmesg|grep i915“ I only see a message which might lead to an error, but I am not sure - „drm - Cannot find any crtc or sizes“ “ls -al /dev/dri“ shows three entries: - drwxrwxrwx by-path - drwxrwxrwx card0 - drwxrwxrwx renderD128 2) Installed binhex-Jellyfin docker from CA repo. Setup transcoding both QSV and VAAPI don’t work. I also read on the forum that you should forward the „/dev/dri/renderD128“ to the docker, which I also did. After loading a video through Jellyfin I see an error that ffmpeg has been terminated with status 1… Does there exist another way to test if the iGPU properly works? I do not really know if the problem comes from the driver load in unRAID, the implementation of Jellyfin or the forwarding into the docker… Thanks and all the best! tower-diagnostics-20230827-1417.zip