supernoman

I am trying to get 2 cards working in my system. Mobo (biostar tz77xe3) will only detect one and only if I put it in the top PCI-E slot. I know both cards are good because I tested them in the top slot and both can get to SAS bios. Green blinking light is on regardless of slot, it just doesn't show up in bios boot or only 1 shows up in SAS config util. Thanks.

Removing the USB boot drive allowed it to go into the SAS config. Status is disabled, Boot Support [Enabled OS Only]. I currently don't have any drive connected. Just ordered my sas/sata cable.

Just bypass. I tried CTRL-C and it didn't go into any menu like when it was with the Dell BIOS. Did I miss a step or was this intentional by other posters for faster boot? Thanks.

I followed the notes from previous page. flashed fw, flashed rom, flashed efi (just in case), flashed sas address back. Not sure which is the BIO's flash.

Registered to provide the answer. megacli -AdpAllInfo -aAll Got my 2 H310's flashed. Is it normal to have the bios say Adapters disabled by user? Hi John Where did you find the SAS addy for the H310? The other cards have a sticker but the H310 does not? don't want to wipe the card until I have the address.. Thanks Mondo