bigdog66

Will Do ...Thank You for the info!

cpu and ram is not too bad to upgrade to get a little more muscle any suggestions? Thanks!

Version 4 and 5 have done me quite well would def love to add the option for dual parity with version 6 so wondering if I will have any issues with my hardware I only use it as a NAS ...at this point I am lost between the differences between plugins and dockers lol my hardware was a pretty standard build in 2010 when I put it together mobo- Asus M4A785-M CPU - AMD Sempron 140 Ram - 2gb Sata - Supermicro AOC-SAS2LP-MV8 I don't know yet if everything can be done through plugins or if anything is now built into unraid but the things I use are UPS Comms Clean Power Down Unmenu Pre_Clear Email Notifications would like to add Sab Sonarr Plex Server - No Transcoding Does anyone see any potential issues hardware wise because im not caught up on current issues the would like to add items are currently running on another pc so its not vital but would be nice to add to my server if you guys think the hardware can handle it It's been a while just because it just runs so Hello to all the new well new to me people lol

well after a few years of rock solid use and just upgrading the size of my six on board disks I decided to finally break down and buy a controller card thought about the dell card but found the issue where you have to tape over certain pins and didn't like the idea of that and decided on what I thought was a old trusty supermicro card by now the AOC-SAS2LP-MV8 It has already shipped so hopefully I didn't screw myself over with this decision as I didn't see the possible issue with it until now crossing my fingers lol

i didn't find any preclear reports but did run a smart report and all looks good what command would I use to run the shortest preclear to have it write the signature

Thanks everyone! that's why I love this place lol

so unless it finished there wouldn't be any record of what happened so even if I run it again and have no reallocated sectors for example I will have no idea if there were any before?

I have been running 3 preclear cycles on a new 4tb drive I know early yesterday afternoon it was on 10% of step 10 I believe and I lost power sometime after 4:47am this morning so I would think it would have finished but the power was out long enough for the battery backup to run out of juice I had it running on an old pc that I was only going to use to do this so like an idiot I didn't setup a clean power down I have always been able to look at the results right after so I can't remember if it saves a log auto or if you have to tell it to save....or is it saves after every cycle or just at the end basically I'm wondering if there is anyway to tell how it went or if it finished considering it died this morning Thanks!