MDEnce

JorgeB - TY Ran a filesystem check, then finally converted to XFS. Working again!

Had some data drive failures. Did a parity rebuild, but then the cache drive got locked. Mover won't run. Can't move anything from Cache drive with SAMBA or MC. Also a couple dockers say they need to update, but the update won't take without the cache drive being unlocked. Please help. Last time I had an issue I needed to post a Dx file, I did it wrong, so I ran Dx, then rebooted (it won't start the array automatically) and ran Dx again, then started array and ran Dx again. Please disregard the ones that don't matter. unraid-diagnostics-20210321-2109.zip unraid-diagnostics-20210321-2100.zip unraid-diagnostics-20210321-2052.zip

That was my original post. I was in the middle of rebuilding Parity 2 and Data Disk 14, when Parity went too. Now I have 3 bad disks. My whole point was how can I get the array to start with the 3 new disks. I'd like to get some parity protection back, even though I realize that disk 14 may be lost. Just don't want to make anything worse if I do a "new config" or something.

I can't start the array with either parity drive, or data drive 14 installed. If I remove them, I can start it. It's running unprotected, and without data drive 14. I shut down the array, reinstalled the 2 parity drives and the data drive 14, and then ran the Diagnostics when it failed to load them. unraid-diagnostics-20210111-1930.zip

Will this one work? unraid-diagnostics-20210110-1030.zip

Here you go - TIA unraid-diagnostics-20210106-2239.zip

I'm on UNRAID 6.9.0-beta35, Pro key. I had 2 parity disks, a cache disk and 19 data disks. (all are XFS except the cache, which is still ReiserFS) Disk 14 went bad, as did Parity2 at the same time. I shut down the array, unassigned the 2 bad drives, and restarted the array. Then I shut down the array again, reassigned each drive and restarted it, and started a parity rebuild. About a day into the rebuild (40-50%) Parity1 went bad too. I stopped the rebuild, shut down the array again, unassigned the 2 parity drives, and discovered that Disk 14 had disappeared. I restarted without any parity, then immediately shut down the array again and tried to restart it, but I keep getting a "Start error" message at the bottom of the Main UNRAID page, and the UNRAiD GUI starts to load the array, hangs, and then dumps me back to the array being stopped. I've tried restarting; shutting down and then restarting; formatting the drives; I even ran preclear on them. But every time I try to start the array, it looks like it's starting, and then dumps me back to the array being shut down. If I remove all 3 disks, the array will start. Help.