sb

Hi, I finally managed to get an h310 for a decent price and tried the above (needed to tap the 2 pins to boot), however i've run in to a slight problem at step 3. While it was doing the first part of this step I noticed it flashed up with an error code 8192 and then did the 2nd part of step 3. I now can't continue any further with the flashing. The card is still detectable using "sas2flash -listall" but says there is no image and exits. Log bits; C:\5_LSI_~1\SAS2FLSH.EXE -l Flashlog.txt -o -f 2118it.bin Advanced Mode Set Adapter Selected is a LSI SAS: SAS2008(B2) Executing Operation: Flash Firmware Image Firmware Image has a Valid Checksum. Firmware Version 16.00.00.00 Firmware Image compatible with Controller. Valid NVDATA Image found. NVDATA Version 10.00.00.00 Checking for a compatible NVData image... NVDATA Device ID and Chip Revision match verified. Valid Initialization Image verified. Valid BootLoader Image verified. Chip is in RESET state. Attempting Host Boot... Firmware Host Boot Successful. Writing Current Mfg Page 2 Settings to NVRAM. Failed to Validate Mfg Page 2! Firmware Returned Exception. IOCStatus=0x25, IOCLogInfo=0x0 Due to error remaining commands will not be executed. Unable to Process Commands. Exiting SAS2Flash. C:\5_LSI_~1\SAS2FLSH.EXE -l info.txt -list Adapter Selected is a LSI SAS: SAS2008(B2) Controller Number : 0 Controller : SAS2008(B2) PCI Address : 00:02:00:00 SAS Address : Undetermined NVDATA Version (Default) : 10.00.00.06 NVDATA Version (Persistent) : 00.00.00.00 ERROR: Failed to Upload Image! Firmware information could not be retrieved BIOS Version : N/A UEFI BSD Version : N/A FCODE Version : N/A Firmware Returned Exception. IOCStatus=0x20, IOCLogInfo=0x0 Due to error remaining commands will not be executed. Unable to Process Commands. Exiting SAS2Flash. Any ideas how to get it flashed correctly please? Thanks :: EDIT:: Flashing the Dell IT works ok, but not LSI P7 or P16.