Andrzej

Thank you very much for hints, I will check it! a.

SBR file attached, .SBR changed to .TXT SBRH310.txt

:) Yesterday I was able to flash the controller from DOS, all steps result: successfull! My old nice almost forgoten DOS dejavu ... The method You point out, is described very clearly, good job, I had no problems. Win-7/64 Device Manager shows that it is a 6 Gbps SAS HBA. Not necessary to install driver after new installation of Win 7/64. Thank you very much for your help! Best Regards, a P.S. The only "problem": SAS Address have not been in the ADAPTERS.TXT file, and on a sticker on the controller card I found a strange sequence of characters, strange because of G and H characters, so I used SAS address from your example: 500605b001f31fa0.

Hello Fireball3, Thank you very much, I think I will try at the weekend, Best Regards, a.

Hello, I am new here, no practice with flashing. I will appreciate very much for help. I installed Dell Perc H310 on the Asus P5-W-64-WS-Pro motherboard, and installed driver on Win-7/64 (Windows boots from HDD, attached to one of SATA mainboard interfaces). And used the H310 as a simple SATA controller, no RAID. Yesterday something made me tempted and I run flashing of my Dell Perc H310 using something I found on Internet: MERGED_20.10.1-0119_SAS_2008_FIRMWARE_Image_APP-2.130.364-1847.zip During reboot I saw typical message, generated by the H310, but...the end of message was like: no response, controller not present. Not possible to get inside the H310 config using Ctrl-R. Windows boots OK,but H310 disappeare. Question: how to fix my H310 ? I will appreciate very much any hint.