luowilliam

My server has been crashing at least once a day. On the screen it says kernel panic. I couldn't get a screenshot of it. It all started about a few days ago. I did not do any major changes to the server. Attached is the diagnostic of my server. Can you guys help take a look at what is going on? nas1-diagnostics-20200409-2240.zip

Actually. Transmission was fixed by deleting the appdata and resintall docker. OpenVPN-as still doesn't work. However, it does not show the certificate error anymore, instead I get the refuse to connect error like I was seeing for transmission.

Deleting the appdata and reinstall the docker worked. Thanks!

Hi guys, I have been having different problems with my server so I decided to reinstall unraid but try to keep the array. The reinstallation went good. I still have my array but needed to reinstall dockers I had. For most of the dockers after resintall from Community Application, the content of the docker was restored automatically and all good. But for Transmission and OpenVPN-as, after resintallation of docker, I can't get into web interface anymore. Transmission says: This site can’t be reached 192.168.1.xxx refused to connect. OpenVPN-as says: Your connection is not private. Gives the chrome page that says the certificate is no good. It doesn't even give you the option to say advance anyway and ignore the warning like some of the other websites that doesn't have "valid" certificate. I've tried deleting the docker and re-installing them without any difference. Need help on what to do next. Any help is appreciated. William nas1-diagnostics-20200217-1126.zip

Still can't figure out what the problem is. It not my network speed as I get same speed as WIFI The SATA cable was switched out as well. I would expect the read speed to be low for files that have not been copied before but writing to the cache drive should be as fast as the network speed, no? Please help. Thanks!

Yes, the cache drive is a SSD. It's attached to motherboard port. I will install the CA trim and try.

I tried copying a movie file over ethernet connection from Windows and MAC... It's just super weird it was working fine up until a week ago. Tried to switch SATA cable didn't make a difference.

I have a 240GB cache drive on my unraid server. I have been getting the maximum writting and reading speed from the server limited by only the Gbit network speed. I think aorund 110Mbps. However recently, the speed dropped way down to 40ish Mbps. It almost seem like the cache drive is no longer working. I checked the cache drive it has no error and I re-formatted the cache drive as well. No change. Any idea where to go next for troubleshooting? Thanks.

What would happen to the installed dockers? Will I need to reinstall them and configure them from scratch?