[docker engine failed to start]

rebooted server and my docker engine won't start.  please help.  attached log

 

tower-diagnostics-20230910-1237.zip

[docker image filling up then emptying out]

I've attached a screenshot of my docker image randomly filling up then clearing itself out.  When it does this my server because unresponsive which isn't a surprise.  How can I tell what is doing this so I can fix it?  I run the scripts from spaceinvader to find orphan images but that's not the issue here.  Its probably log files filling it up but I have no idea what they could be from. I have also attached my diagnostic logs if those can help.  Any help would be appreciated.  Thanks

 

 

tower-diagnostics-20230129-2051.zip

[very bad cache read and write speeds]

I am rebuilding my cache array after upgrading the SSDs.  When I copied my cache drive information to my array it was going at around 2-5mb/sec which is terrible but I thought the SSDs were going bad since they were old.  I put in 2 Samsung EVO 840s for my cache and its writing the data back at 5-10mb/sec which seems very slow to me.  I have attached my diagnostics, and I can provide screenshots if necessary.  I also upgraded to 6.9 RC2 because of the SSD write improvements it has for the cache drives, but can roll back to 6.8.3 if necessary.  Any help would be appreciated.  Thanks

tower-diagnostics-20210119-2326.zip

[slow data copies/parity rebuild]

When the mover stops it goes at about 35MB/sec for the parity rebuild.  Is that what I should expect?

[slow data copies/parity rebuild]

My parity rebuild is going very slowly.  I am trying to upgrade all of my 3tb drives to 6tb.  Currently I have 8 3TB drives and 4 6TB drives and I'm pre-clearing 4 more 6TB drives.  I just took out 4 3TB drives so I did a new config and the parity is going very slowly and I don't know why.  The new drives are SAS 7200RPM drives on a 6GB/sec LSI raid card flashed to IT mode.  I've attached my diagnostic file as well.  Any help is greatly appreciated.  

 

Thank you.

tower-diagnostics-20200219-1937.zip

[[Support] Linuxserver.io - Transmission]

I apologize if this has been asked before, but how do you pipe the traffic out from this docker to a VPN?  I know other people include VPN settings in the docker setup but I would rather use the Linuxserver dockers and its not clear how this works for the torrent dockers.  Thanks in advance.