longsh0t

Parity sync finished and still having issues. Now if I go to the share directly I can't see anything. \\movieserver1\movies\Action show no files. If I go to the each individual disk i can see the files! \\movieserver1\disk1\movies\Action \\movieserver2\disk2\movies\Action etc I'm still not sure what to do at this point. Should I do a new config again?

I am running an old version of unRAID (5.0.6)as this was my first unRAID server. It did it's job and I didn't see a need to upgrade yet. I had a disk go bad and attempted to replace it. I replaced the bad drive with a pre-cleared drive, booted up and then unRAID said 2 of my disks were unformatted. After doing some Googling, I did a new config and did a parity sync. That was last night. I checked it just a while ago and now I'm missing a ton of data. I'm assuming what I did was not the correct thing to do. I had a 10TB array and in my largest share (movie) it says I have 1.14TB of data. The odd thing is that when I am in the console it unRAID says that every drive is basically full (76GB free out of 9.93TB). It seems like the data is there but I have no idea how to fix it or if it's even fixable. I've attached a syslog and screenshot. Please let me know if I need to provide anything else. FYI parity sync is still technically running and has about an hour left but it doesn't look promising that any of my missing data is going to be recovered after it's done. Thank you in advance. syslog.txt syslog.txt

Got a new USB and plus.key (Thanks, Tom!). All up and running now. Thank you everyone for your help. Definitely going to backup my config now.

Thank you. Any suggestions on how to identify which one was my parity drive?

Unfortunately, no. I think I may be rebuilding it at this point since I don't have a backup. Not sure if I should make a new thread or not but as long as I don't add the parity drive does it matter what order I put the data drives in? I honestly do not remember which drive went where.

Can you tell me how to get to /boot/ and how to mount it? I can telnet to the server but I'm not sure what to do from there.

Came across another thread where it said to try running "ls -l /dev/disk/by-label" to see if was labeled properly. It wasn't so I went to see if I could change the volume label on my PC and it wouldn't recognize my USB drive. Connected it back to my unraid server and it boots (can get to root), I can telnet to it but it still can't access the web interface to start the array. Is there any way to backup the USB config over telnet so I can maybe try a new USB drive?

I recently had issues with one of my UnRaid servers where a contractor working on my kitchen turned off the breaker for my servers by mistake. One of my servers booted up fine but the other one froze loading "bzroot". I put the USB drive into another USB port and it booted normally (could get to root) but I couldn't access it via the web interface. After some searching I came across this thread and used the following command to reset the webserver. killall emhttp /usr/local/sbin/emhttp & I went to the web interface via IP and it came up but it look completely reset. No drives were selected and it looked like it a basic license instead of my Plus license. I restarted the server again and I'm back to square one (can access root but no web interface to start the array). I am running unRAID Server Plus, Version 5.0-beta14. I haven't bothered upgrading because everything has been working just fine for what I need. I'm at a loss of what to try nice so any advice would be greatly appreciated.