rum-z

Thank you. Sadly that did not work, I ended up wiping the drives, and starting fresh, back to bttrfs for the cache drive. Thankfully I had backups. I'll look into the bad RAM. I wonder if bad RAM broke the zfs since it uses RAM.

I recently switched to ZFS for my cache because I thought it would be more reliable than BTTRFS. I'm about a month into it and experienced my first corurption already. I'm seeing: PANIC at range_tree.c:436:range_tree_remove_impl() I am new to zfs. Are there any good recovery methods for ZFS? For extra contedt: I've been using 6.12.6 since it came out syslog

Thank you. I turned off bridging on eth0. I'll give it a few days and then mark the issue as resolved

Sys logs attached. This time I turned off the server gracefully. It did not lock up. However, 5 min after I turned it off, the server was still "on" with fans spinning and LEDs inside the case on. Yet I couldn't access the web gui. syslog

Thank you. Waiting on it to fail again. I'll respond when it does. I turned on syslogs and am having them write to the OS USB flash drive (temporarily until i get the logs I need)

Hi, I've been using unRAID for 4 years now, and it's been great until 6.12. I'm currently on 6.12.6, and my server keeps on randomly crashing on me. I end up losing access to the web GUI, but the server is still on with the fans spinning. My most recent incident had the web gui booted and once it finally crashed (takes around 10-12 hours each time). Even with the web gui I had a static image that was suck and my mouse could not move. The only fix is to hard reset by holding the power button down. Has anyone experienced this and has a fix? I attached some logs and diagnostics vader-diagnostics-20240109-1804.zip vader-syslog-20240110-0212.zip