another_hoarder Posted March 9, 2021 Share Posted March 9, 2021 Hi fellow un-raiders, I've been on 6.9.0-stable for several days without any issues (other than the AutoFan extension causing disks to not spin down) and eager to do some disk shifts, for the first time ever. I'm on Unraid OS-Plus, 10 disk array (9+1 partity) + 1 cache SSD + 1 unassigned SSD. My array has only had a few purpose bought drives and a ton of leftovers ... so here's what I'd like to get done with two newly shucked 14TB Seagate Expansion drives: - replace my single parity drive (shucked 14TB replaces 4TB WD Red) - replace another drive (4TB with smart error will get replaced by above 4TH WD Red) - replace super old drive (1TB drive with will get replaced by the 2nd 14TB shucked drive) So - do I need to still preclear the new 14TBs? Within array or run them via basic DBAN? And any suggestions on getting the above accomplished without too many clicks or days spent on the maintenance? Thanks! (Visually - new 14TBd1 becomes Parity, new 14TBd2 becomes Disk 5, old Parity 4TB becomes Disk 6. ) Quote Link to comment
itimpi Posted March 9, 2021 Share Posted March 9, 2021 You are going to have to do the changes in 3 steps (starting with the parity drive) as with single parity you can only do 1 disk at a time. Preclearing the disk(s) is not required unless you want to run an initial stress test before committing them to the unRaid array. Also you cannot run preclear against a disk that is already part of the array. Quote Link to comment
another_hoarder Posted March 9, 2021 Author Share Posted March 9, 2021 Perfect, thanks @itimpi. I've started on the path of doing parity swap + move parity to data as 1 step (eg making the two drives go blue, starting 'Copy Parity' function). It's at 45% right now. I'm hoping that when it finishes I can just start the array and allow parity to rebuild the 1TB data onto the old 4TB parity drive. Thus I'll have done first two steps as really one step. When that's done I can replace the last drive with the 2nd 14TB and again allow for a parity rebuild. So potentially two steps all in all. Quick sanity check, does that look alright? Quote Link to comment
itimpi Posted March 9, 2021 Share Posted March 9, 2021 2 minutes ago, another_hoarder said: Perfect, thanks @itimpi. I've started on the path of doing parity swap + move parity to data as 1 step (eg making the two drives go blue, starting 'Copy Parity' function). It's at 45% right now. I'm hoping that when it finishes I can just start the array and allow parity to rebuild the 1TB data onto the old 4TB parity drive. Thus I'll have done first two steps as really one step. When that's done I can replace the last drive with the 2nd 14TB and again allow for a parity rebuild. So potentially two steps all in all. Quick sanity check, does that look alright? That will work but actually since the parity swap procedure first works on the parity drive first and then only starts on the data drive when that completes it automatically starts rebuilding the data drive so does not really save much time over doing it in 2 steps. I would have kept them separate just so I had points at which I could check that the previous step was OK. Quote Link to comment
another_hoarder Posted March 9, 2021 Author Share Posted March 9, 2021 OK, thank you kindly! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.