September 23, 20214 yr I switched out my hardware and now Unraid won't complete the boot sequence. It stops at "starting rsyslogd daemon: /usr/sbin/rsyslogd -i /var/run/rsyslogd.pid" It just hangs there with a blinking cursor forever and goes no further. I'm not sure where to begin to diagnose the issue since I can't get to a log-in prompt and it hangs before I can access any of the management interfaces. I changed my motherboard, CPU, and RAM but I don't think it's related? Unraid will load a "clean" install but not my previous config so it might be related?
September 23, 20214 yr Community Expert Be sure to boot from USB2 port, they are more reliable for this and speed isn't important. 7 hours ago, zelet said: Unraid will load a "clean" install Is that using the same flash drive or another one?
September 30, 20214 yr Author It was a new USB drive. Although I installed the old hardware and the old USB booted the system fine.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.