Mike-D Posted September 29, 2021 Share Posted September 29, 2021 Parity check keeps running over and over. It find the same amount of errors but does not correct the errors. SMART data looks good. Diag attached. nas-diagnostics-20210929-0932.zip Quote Link to comment
JorgeB Posted September 29, 2021 Share Posted September 29, 2021 Sep 29 08:41:18 NAS emhttpd: unclean shutdown detected An auto-parity check starts after any unclean shutdown, and it's non correct, so you need to run a correcting check, and figure out what is causing the unclean shutdowns. Quote Link to comment
Mike-D Posted September 29, 2021 Author Share Posted September 29, 2021 19 minutes ago, JorgeB said: Sep 29 08:41:18 NAS emhttpd: unclean shutdown detected An auto-parity check starts after any unclean shutdown, and it's non correct, so you need to run a correcting check, and figure out what is causing the unclean shutdowns. Weird. This started a couple days ago and this is like the 3rd parity check to complete I guess I should setup some kind of monitoring to see when unraid goes offline. I'll run the following to see what it comes up with. Quote Link to comment
Mike-D Posted September 30, 2021 Author Share Posted September 30, 2021 Resolved Unraid plugged into a zigbee smart switch controlled by home assistant. The zigbee coordinator is dyeing and for some reason turning off the plug then turning it back on. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.