jbrukardt Posted October 30, 2022 Share Posted October 30, 2022 Diagnostics are attached, Something glitched and I lost a parity drive (Parity 1), physical failure, and then subsequently during the parity rebuild after physical replacement I had another disk "disabled", Disk 7. I checked SMART on the disk and it seemed fine, so i unassigned it, cycled the array, reassigned it, and booted the array back up. Upon letting the array start up, it seems to be in a bad place. Parity sync is occurring @ 800 kb/s and will take 100 days to complete. 8 TB Elapsed time:21 minutes Current position:1.33 GB (0.0 %) Estimated speed:785.6 KB/sec Estimated finish: 108 days All these drives were precleared about 2 weeks ago, had roughly 80TBs of data written to them, and then the parity drive failure occurred. tower-transfer-diagnostics-20221029-2323.zip Quote Link to comment
JorgeB Posted October 30, 2022 Share Posted October 30, 2022 This happening for multiple devices: Oct 29 20:05:29 Tower-Transfer kernel: sd 1:0:4:0: Power-on or device reset occurred Oct 29 20:05:29 Tower-Transfer kernel: sd 1:0:7:0: Power-on or device reset occurred Oct 29 20:05:29 Tower-Transfer kernel: sd 1:0:1:0: Power-on or device reset occurred usually suggests a power/connection problem. Quote Link to comment
jbrukardt Posted October 30, 2022 Author Share Posted October 30, 2022 Shoot, I see it in syslog all over the place. Doesn't seem to be on a single minisas, so I expect the controller may be overheating, or I have bad power connections. It does have a few splitters in it, but it's unavoidable with this PSU. Quote Link to comment
jbrukardt Posted November 7, 2022 Author Share Posted November 7, 2022 new diagnostics tower-transfer-diagnostics-20221107-1240.zip Quote Link to comment
JorgeB Posted November 7, 2022 Share Posted November 7, 2022 It's detecting new errors after the correcting check, start by running memtest. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.