FelixDaPoodle Posted November 23, 2022 Share Posted November 23, 2022 Hi All long time user, 1st time poster. I had a drive fail the other day and it switched to emulated. I ordered a new drive. When the new drive arrived, I shut down the system (cleanly), swapped out the drive and assigned to the slot of the old drive. Started the array and started a rebuild. All went well up to about 50% then it has basically stalled. 71kb/s. 600days to compete. Diagnostics attached. Any ideas? Thanks heaps Matt caroline2-diagnostics-20221123-1756.zip Quote Link to comment
JorgeB Posted November 23, 2022 Share Posted November 23, 2022 Unraid driver crashed, try rebooting, the rebuild will re-start from the beginning, then hopefully it won't crash again. Quote Link to comment
FelixDaPoodle Posted November 24, 2022 Author Share Posted November 24, 2022 Hi Jorge Thanks! I rebooted and ran again. Must have got close to completion but when I got up this morning the system must have rebooted. Not sure why... I have started the rebuild again (3rd time) hopefully will complete. Cheers Matt Quote Link to comment
JorgeB Posted November 24, 2022 Share Posted November 24, 2022 Might be a good idea to enable the syslog server to see if it catches something if it happens again. Quote Link to comment
FelixDaPoodle Posted November 24, 2022 Author Share Posted November 24, 2022 Hi Jorge Thanks for your help. It crashed again before it completed. I have enabled the syslog server and started the rebuild again. Hopefully it works. Cheers Matt Quote Link to comment
FelixDaPoodle Posted November 24, 2022 Author Share Posted November 24, 2022 Hello again Jorge crashed again, I looked though the syslog (attached) and it looks like it may be crashing when the mover starts. I think I have disabled the mover using the mover tuning plugin. Is there any way to disable the mover for sure? Thanks again for your help Matt syslog-192.168.1.19.log Quote Link to comment
Solution JorgeB Posted November 25, 2022 Solution Share Posted November 25, 2022 Nothing relevant logged, this usually points to a hardware issue, start by running memtes, if you have a different PSU you could test with it might also be a good idea. Quote Link to comment
FelixDaPoodle Posted December 7, 2022 Author Share Posted December 7, 2022 Hi Jorge Thanks for you help. Turned out to be a bad stick of ram. Array all heathy now. Thanks again Matt 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.