After upgrading from 6.9.2 to 6.11.5, the server, pool and all auto-start containers started. However, the webUI for all containers will not work except for Jellyfin. So I reverted back to 6.9.2.

A while ago I tried to upgrade then to 6.10 and later to 6.11.2 but faced the same problem on both counts.

Your help will be greatly appreciated.

unraid-diagnostics-20221204-1656.zip

Backup then recreate you flash drive and restore from the backup only the bare minimum, like the key, super.dat and pools folders, docker user templates, etc. and see if that helps.

Should I do this while at the current version I am on (6.9.2) or after I upgrade to 6.11.5?

Doesn't matter, but recreate the flash drive with the v6.11.5 install.

Thanks for the reply. Since your first reply, I have been looking at the content of the flash drive trying to comprehend what I need to do. I have also located one of your posts about rebuilding a flash drive. Will try to rebuild the flash and see how it goes.

I have not had the time to rebuild the flash as of yet but will soon. Honestly, I am a little afraid that If things don't work well and I loose my apps settings. I am not worried about re-configuring the ARRAY and POOL drives.

Meanwhile, I installed v6.11.5 and did the following and found out something interesting that may give you a clue as to how to resolve this problem:

1) All the auto-start apps started properly. I was able to get the GUI for 6 of them (Plex, Wireguard, Jellyfin, Nginx, Jellyseerr and Speedtest). The GUI would not start for 7 apps (Radarr, Sonarr, Nzbget, Unmanic, Krusader, Ombi and Handbrake)

2) I deleted Handbrake (I hardly use it) and removed the container completely and then reinstalled it. All went well and the GUI started. 

3) I tried to start Krusader but as mentioned above, the GUI screen is unable to connect. Normally the url is something like this

http://10.0.0.74:6080/vnc.html?resize=remote&host=10.0.0.74&port=6080&autoconnect=1.   I changed it to 10.0.0.74:6080 and got the screen below.

 

 

I restarted Krusader GUI again and I got the message that it is the first time I am starting Krusader and started the configuration. However, at one stage I got the following message

"Krusader's configuration file is in READ ONLY mode (why is that!?) Changed values will not be saved".

I hope that the above message will help you figure the cause of the problem.

 

Regards,

 

 

7 hours ago, Farid said:

"Krusader's configuration file is in READ ONLY mode (why is that!?) Changed values will not be saved".

If there are no filesystem errors on the syslog it could be permission issues.

Did not see filesystem errors. Anyway, I reinstalled Krusader along with the other 6 apps that would not allow starting the webUI and had them reconfigured. A couple gave me problems such as sonarr with permissions (can't understand why as it was the exact same version I had b4 and I had it set exactly as it was b4 using screen shots of the settings I had saved of the one that was installed) and nzbget with TLS. Finally, I now have 6.11.5 installed and all apps working perfectly.

Thanks for your help