Suddenly my parity disk went red. So I stopped the array, marked parity check and started the array. After that the unraid gui went short unresponsive and after a few seconds the array is started without the parity, which gets 384 Errors.

 

I don't know the reason for the errors, so I ask you. I hope the drive is not broken.

 

I'm using the latest Beta 12a

 

The Parity is a WD20ears unjumpered and I transfered before 1,5TB of Data per LAN to my array without any problems.

 

Syslog.txt

Line 1060: Sep  9 10:44:51 Tower kernel: ata5.00: exception Emask 0x10 SAct 0x0 SErr 0x400000 action 0x6 frozen

Line 1061: Sep  9 10:44:51 Tower kernel: ata5.00: irq_stat 0x08000000, interface fatal error

Line 1062: Sep  9 10:44:51 Tower kernel: ata5: SError: { Handshk }

Line 1063: Sep  9 10:44:51 Tower kernel: ata5.00: failed command: WRITE DMA EXT

 

Run a smart test on the parity drive and post here.

 

http://lime-technology.com/wiki/index.php?title=The_Analysis_of_Drive_Issues#Drive_problems_by_keyword

 

Handshk errors are typically interface (cabling) issues..

http://lime-technology.com/wiki/index.php?title=The_Analysis_of_Drive_Issues#Drive_Interface_Issues

Thanks!

 

Smart Status: Failing

                   Get data off disk and run advanced tests below for more information

 

SMART Information: Short INQUIRY response, skip product id

                          A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options.

 

SMART Extended Test: Disk must be spun up before running tests

 

I used the option "spin up" on the mainmenum, but the SMART Extended Test says the same.

 

//edit:

 

I changed power and sata cable and there are no errors in the first few minutes. I report back! Thanks again!

Ok I tested again, it's the SATA cable. Power cable is ok. solved