November 7, 20232 yr Hello, after some power problems, my Unraid server is missing 2 drives, unsupported or missing file system. One of the drives is disabled, but the data on it are still emulated, the other one does not even show that red indicator. XFS repair replaced the primary super blocks but is stuck at stem 2 because the Log files are empty or zeroed. any ideas on how to repair or rescue my array ? cheers tower-diagnostics-20231107-0342.zip
November 7, 20232 yr Community Expert Check/replace cables for disk2 and post new diags after array start.
November 7, 20232 yr Author Hello JorgeB et al here is a newer diagnostic file.i changed the Powersupply cables as well as the data cables. Disk 01 as well as disk 02 are still emulated but the plethora of errors i saw in the xfs repair report with the -n optopn are really bothering me. If i resart the array another resync will be initiated, that will take about 48 hours to complete. if I run a complete pre-clear you need to ad about 2x48 hours as well .... here is the new diag - cheers tower-diagnostics-20231107-1705.zip
November 7, 20232 yr Community Expert 25 minutes ago, ahab666 said: Disk 01 as well Do you mean you also replace cables for that one? There are now issues with disk1.
November 7, 20232 yr Author Yes i had to - my controller has mini SAS combi ports, 16 channels and 4 jack ports, the cable splits up halfways and the HDDs are connected via 4 seperate jacks (sata). There were all ready issues with both disk 01 and Disk 02 when I sent my original post - both disks were unmountable, but disk 2 had a different indicator in front. Disk01 had the red disabled icon, while disk 2 has the orange warning triangle. There are issues with both Disks, what really troubles me is the fact, that as soon as I start the array in non maintainece I see boatloafs of read errors on the parity 2 drive any ideas what's going on cheers
November 8, 20232 yr Author Hello again, That I cannot do, because UNRAID than states wrong disk. Cheers
November 8, 20232 yr Community Expert Just swapping ports cannot show wrong disk, unless you are using RAID controllers.
November 8, 20232 yr Author Well, it did, and I am definitely not using a RAID controller - just a pure HBA. I just wonder if I should add two new replacement disks to the array and copy the emulated files to them ? Now I need to prepare for my vacation - I will be away for 2.5 weeks starting with Friday. But I'll be back cheers and thx for your help so far
November 8, 20232 yr Community Expert 36 minutes ago, ahab666 said: Well, it did, and I am definitely not using a RAID controller - just a pure HBA. Then it cannot show wrong just by swapping ports.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.