This morning the web interface was unavailable however I was able to properly powerdown the server via console and reboot.

 

After rebooting the web interface was working again.  I looked at the syslog.  I noted memory, unmenu and other errors.  I may power down the server again and reseat all 4 memory modules.

 

Can someone please take a look at my syslog (attached) and help me understand all the error messages?  Thank you.

unraid_syslog-2012-03-31.zip

Hi, I'm now attempting to power down the server but disk5 is stuck unmounting.  I've searched the forum messages for examples and tried several commands to identify the process(es) that might be causing the problem but am stuck.

 

Can someone please look at the ps ux_output file and/or the latest syslog (attached to this message) and help me out?  I'm not sure what to do next.  I'm running v4.7  Thank you.

ps_ux_output.zip

syslog-2012-04-03.zip

smart_report_of_disk5.txt

Enter "lsof /mnt"

I just had the same issue (I think). All of my drives were stuck "unmounting" so I went to the unmenu array tab and clicked "stop" there, and the array stopped immediately. I don't know what caused the issue with the unRAID interface.

I issued the "lsof /mnt" command from telnet, no luck...

 

Then went to the "Array Management" tab in unmenu and clicked "Stop Array", no luck...

 

Results of "lsof /mnt" below:

 

root@Tower:~# lsof /mnt

lsof: WARNING: can't stat() fuse.shfs file system /mnt/user

      Output information may be incomplete.

 

Should I hold in the power button to force the unRAID server to shut down?  What is the worst that could happen as a consequence?  A parity check on re-boot?

Should I hold in the power button to force the unRAID server to shut down?  What is the worst that could happen as a consequence?  A parity check on re-boot?

http://lime-technology.com/wiki/index.php/Console#To_cleanly_Stop_the_array_from_the_command_line

 

If that does not work, yes, about the worst is a parity check on reboot.