January 26, 20251 yr As titles suggets I moved my LSI controller from PCI_e3 to PCI_e1 to make use of faster speeds. Booted server up and all was fine, after installing powertop I need to reboot and now all disks are showing as showing as read only but then say If the disk has not been disabled, then Unraid has successfully rewritten the contents of the offending sectors back to the hard drive. It would be a good idea to look at the S.M.A.R.T. Attributes for the drive in question Main page doesnt show any issues which is weird right? I started parity check but just shit load of errors show up! So in abosolute PANIC mode right now! Fix Problems Page Main Page server-diagnostics-20250126-1402.zip Edited January 26, 20251 yr by bally12345
January 26, 20251 yr Author After stopping the array it looks like all the disks are missing, going to shutdown and make sure the card is seated correctly. Might just move back to the original slot?
January 26, 20251 yr Author Moved it back and everything is working but would like to understand what happened if possible and whether I should just leave LSI controller in 4x PCI slot and call it a day.
January 26, 20251 yr Community Expert Solution The HBA reset itself, you can try again and make sure it's well seated, but it could also be a compatibility issue with the board and the HBA in that slot.
January 26, 20251 yr Author 32 minutes ago, JorgeB said: The HBA reset itself, you can try again and make sure it's well seated, but it could also be a compatibility issue with the board and the HBA in that slot. Going to leave it in PCI_e3 too much stress!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.