September 13, 2025Sep 13 Hi all - apologies in advance for being a moron.My USB drive died a death, and spent a couple of days trying to get the config folder off it. Finally did, and managed to get everything back up and running. In doing so, I upgraded to 7.1.4 and was delighted to see that wifi was now supported. During the setup process of the new USB drive, I did see that wlan0 was available to me in the network settings, but at the time was using a wired connection to get everything redone. I've since shut down to move the box back to its normal position in the house, but there's work going on and temporarily need to use wifi for a couple of weeks until the house's Cat6 gets sorted. But on spinning everything back up, wlan0 isn't showing up in the Network Settings GUI - just eth0 and eth1, extra, rules, and routing table. During the boot, I can see that wifi is detected.Motherboard is an ASRock H270M-ITX/ac.Any suggestions on getting it back up and running?
September 13, 2025Sep 13 Author Sorry trurl - remember when I said I was a moron? 🤣 thebox-diagnostics-20250913-1254.zip
September 14, 2025Sep 14 Sep 12 18:30:32 TheBox kernel: iwlwifi 0000:03:00.0: Failed to run INIT calibrations: -110Sep 12 18:30:32 TheBox kernel: iwlwifi 0000:03:00.0: Collecting data: trigger 16 fired.Driver is failing to initialize, and you say it worked before? Any changes in hardware? It may also be worth testing with 7.2.0-beta.2, newer kernel might help.
September 14, 2025Sep 14 Author Yep, worked before, and was able to see and connect to the home wifi after the initial setup and registration switch. Will have a go with the beta and see if that helps.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.