interwebtech Posted October 7, 2014 Share Posted October 7, 2014 The whole process of initializing all the connected drives isn't displayed anymore? Goes straight to unRaid boot menu after the mainboard POST process. Anyone seen this before? Once unRAid boots I can see all the connected drives and the device is listed in unMenu PCI devices. I swapped in another AOC-SASLP-MV8 with no change. Very odd. Link to comment
demonmaestro Posted October 7, 2014 Share Posted October 7, 2014 sounds like something in either BIOS or under the settings of the card that i think is CTRL+S when its booting. However if you are able to see the connected drives in unRaid then personally I would not be worrying. Link to comment
Bungy Posted October 10, 2014 Share Posted October 10, 2014 Agreed. On many motherboards, there is a setting that will disable booting the firmware for the raid card. As long as you don't need to change any of the settings on the card and the drives show up in unraid, you should be fine. Most people disable booting the card firmware to speed up the overall boot process. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.