December 30, 20178 yr Tried using 6.3.4 and 6.3.5 to no avail. Basically what I am seeing is during boot of unraid OS it does it's normal thing pretty quickly and then gets stuck at "[TTM] Initiializing pool allocator" Basically everything I can see on screen while it is stuck is as is below: <code>mpt2sas_cm0: 64 BIT PCI BUS DMA ADDRESSING SUPPORTED, total mem (66016600 KB)<br> scsi host1: isci<br> scsi host2: ahci<br> scsi host3: ahci<br> scsi host4: ahci<br> scsi host5: ahci<br> scsi host6: ahci<br> scsi host7: ahci<br> scsi host8: ahci<br> [drm] AST 2300 detected<br> [drm] VGA not enabled on entry, requesting chip POST<br> [drm] Analog VGA only<br> [drm] dram 1632000000 1 16 00800000<br> [TTM] Zone kernel: Available graphics memory: 33008300 kiB<br> [TTM] Zone dma32: Available graphics memory: 2097152 kiB<br> [TTM] Initializing pool allocator</code> I have the exact same model of a server below the one I am trying to use, they are identical minus the RAM and hard drive numbers. The USB device I created for the new server works on the existing server and also other hardware so I don't think it is the USB flash device. I saw some other posts about networking preventing boot up but i don't think that is the issue because I see a line about unRAID using Intel drivers. When I try to boot to the GUI the screen goes black with a blinking cursor, never changes. With both versions. Any thoughts? SOLVED: I just used version 6.4.0-rc9f. booted right up no problem. Edited December 31, 20178 yr by spx404 Solved
Archived
This topic is now archived and is closed to further replies.