Active Array Device also in Historical Devices as Missing

[rbroberts]

I have a device which is appearing in the "Historical Devices" section as missing, but it's the same identification as an active array device. I'm not quite sure how to clear this and if I can just safely hit the "Remove Config" link on the Main tab.

 

Unraid 6.7.2

Supermicro X9DAi

2 x XEON E5-2695v2

128 GB Memory

2 x WDC WD101KFBX 10 TB Array

2 x Samsung 860 EVO 2 TB Cache

[dlandon]

It's probably because you had the disk in UD and then put it in the array.  Please show a screen shot and post diagnostics.

[rbroberts]

Screenshot and diagnostics attached.

I also just had an error pop up with a corrupt flash, the screenshot and diagnostics are from after the recovery from that. Unfortunately, I didn't have a recent backup of the flash where I was sure that super.dat was up-to-date, so the array thinks it was shut down dirty and is now doing a parity check.

 

tower-diagnostics-20190930-1627.zip

Edited September 30, 2019 by rbroberts

[dlandon]

3 hours ago, rbroberts said:

Screenshot and diagnostics attached.

I also just had an error pop up with a corrupt flash, the screenshot and diagnostics are from after the recovery from that. Unfortunately, I didn't have a recent backup of the flash where I was sure that super.dat was up-to-date, so the array thinks it was shut down dirty and is now doing a parity check.

 

tower-diagnostics-20190930-1627.zip 126.53 kB · 0 downloads

Just remove the historical device.