gustovier Posted May 26, 2020 Share Posted May 26, 2020 All, I just recently converted all my disks from ReiserFS to XFS, and afterwards I figured it was a good idea to do a parity re-sync (I just use 1 parity drive). Which I believe was a good idea because there's currently 412K sync errors that's been corrected and it's only 30% done. The speed of the parity sync seems to also be moving at slow. The sync has been running for about 4 days/14hrs thus far and it's initial speed as like around 1mb/s. At some point the speed has risen to about ~66mb/sec (all 8 of my disks including parity are reading at about that same rate now) and now there's only about 1 day left so I might as well let it finish. Is this normal or are there some issues somewhere? tower-diagnostics-20200526-0845.zip Quote Link to comment
JorgeB Posted May 26, 2020 Share Posted May 26, 2020 Constant ATA errors on both disk3 and parity, check cables. Quote Link to comment
gustovier Posted May 26, 2020 Author Share Posted May 26, 2020 7 hours ago, johnnie.black said: Constant ATA errors on both disk3 and parity, check cables. Ok, to make matters worse.. My Power went out a few mins ago causing the machine to go down no so gracefully. So looks like I'll be starting this process all over again now Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.